The bearings of vacuum dryer need to be carefully inspected and periodically inspected to ensure the service life and long-term operation of vacuum dryer. Today we will introduce some preparations.

1。旋轉外圈，仔細清洗籠子、滾筒和滾道連接器，徹底任何先前隱藏的殘留物。真空干燥器南京SKF軸承應靠近干洗清洗，清潔襯里中性支撐干燥，或在遠紅外線干燥箱中緩慢干燥。

1. Rotate the outer ring, carefully clean the cage, drum and raceway connectors, and thoroughly remove any previously hidden residues. Nanjing SKF bearings of vacuum dryer should be cleaned close to dry cleaning, clean liner neutral support drying, or drying slowly in far infrared drying box.

因?yàn)檫B續干洗接近于干燥或干燥，所以整個過程不應該放置在真空干燥機的軸承環上，并粘附在任何框架或輥?zhàn)由?。真空干燥機軸承油可從密封包裝中提取，浸漬在3個點無酸煤油或汽油洗滌劑中，然后送往實際測試。·

Because continuous dry cleaning is close to drying or drying, the entire process should not be placed on the bearing ring of a vacuum dryer and adhered to any frame or roller. Bearing oils for vacuum dryers can be extracted from sealed packages, impregnated in acid-free kerosene or gasoline detergents at three points, and then sent to the actual test. ·

2。檢查南京SKF軸承是否滴入潤滑油，并立即輸送干式或干式真空干燥器。沒有油膜來保護軸承的外表面。檢查人員不允許在整個過程中直接接觸皮膚。操作人員應戴上干凈的手套，涂上帶銹的油漆，但須避免將軸承放在防銹攪拌輥真空干燥機上，否則測量結果會產生偏差。

2. Check whether the SKF bearing of Nanjing is dripped into lubricating oil, and immediately deliver dry or dry vacuum drier. There is no oil film to protect the outer surface of the bearing. The inspectors are not allowed to contact the skin directly throughout the process. Operators should wear clean gloves, coated with rusty paint, but must avoid putting bearings on the rust-proof mixing roller vacuum dryer, otherwise the measurement results will be deviated.

3。生銹的原材料應立即供應或處理。整個檢查過程應在真空干燥機軸承檢查后完成。時間過長，以免造成腐蝕。要注意使用清潔和無油的純汽油，這也會引起腐蝕。

3. Rusty raw materials should be supplied or disposed of immediately. The whole inspection process should be completed after the bearing inspection of the vacuum dryer. The time is too long, so as not to cause corrosion. Attention should be paid to the use of clean and oil-free pure gasoline, which will also cause corrosion.

4。如果真空干燥機的南京SKF軸承是干的或干的，潤滑油應滴入軸承的外表面，而不需要真空干燥機的薄膜保護，并應根據需要檢查是否及時交付。此時，在整個檢查過程中不允許與皮膚直接接觸。操作者應戴干凈手套和手銹，但須避免防銹劑。真空干燥機的滾動表面與手混合，否則將測量結果的偏差。

4. If the Nanjing SKF bearing of the vacuum dryer is dry or dry, the lubricating oil should be dripped into the outer surface of the bearing without the film protection of the vacuum dryer, and should be checked for timely delivery as required. At this point, direct contact with skin is not allowed during the entire inspection process. Operators should wear clean gloves and hand rust, but avoid rust inhibitors. The rolling surface of the vacuum dryer is mixed with the hand, otherwise the deviation of the result will be measured.

5。真空干燥機南京SKF軸承在交付后或腐蝕檢查后應立即檢查。檢查過程不應持續太久，以免腐蝕。要注意使用清潔和無油的純汽油，這也會引起腐蝕。

5. Vacuum dryer Nanjing SKF bearing shall be inspected immediately after delivery or after corrosion inspection. The inspection process should not last too long to avoid corrosion. Attention should be paid to the use of clean and oil-free pure gasoline, which will also cause corrosion.

6。在南京SKF軸承檢查前，為了在室溫下快速均勻化這些物體，印制了一些測量塊、標準件、測量儀器和金屬檢查板用于辦公室檢查。

6. Before SKF bearing inspection in Nanjing, in order to homogenize these objects rapidly at room temperature, some measuring blocks, standard parts, measuring instruments and metal inspection boards were printed for office inspection.

顯然，只有嚴格的準備才能保證試驗結果的準確性，真空干燥機軸承在整個試驗過程中不會生銹。

Obviously, only strict preparation can ensure the accuracy of the test results, vacuum dryer bearings throughout the test process will not rust.

文章來自：南京SKF軸承 www.wh-skf.com

The article is from: Nanjing SKF bearing www.wh-skf.com

文章來自：南京INA軸承 www.ina-china.cn

The article is from: Nanjing INA bearing www.ina-china.cn

文章來自：南京NSK軸承 www.klbbearings.com

The article is from: Nanjing NSK bearing www.klbbearings.com

QQ：524085168

電話：0510-81207777

手機：13311666672

【溫馨提示】以上是鴻御（上海）國際貿易有限公司供應的深溝球軸承--真空機中南京SKF軸承16017的活期預備的詳細信息，歡迎您在驛路商務查看深溝球軸承的新的價格、廠家、型號、圖片等信息。本頁所展示的信息由企業自行提供，內容的真實性、準確性和合法性由發布企業負責，"驛路商務"對此不承擔任何保證責任。同時鄭重提醒各位買/賣家，交易前請?jiān)敿?xì)核實對方身份，切勿隨意打款或發貨，謹防上當受騙。如發現虛假信息，請積極舉報。[我要舉報]

• 下一產品：鄭州天地人全自動刨肉機
• 上一產品：臨西軸承22232CA/W33科瑞機械軸承